Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Section 7. Maintenance
WARNING
To avoid electric shock and other hazards which could result in
permanent injury or death, disconnect (unplug) the cleaner from the
power source before performing any cleaning and maintenance.
7.1
Cord Tangling
Tangling can occur more frequently when the
cleaner is not attended to after each cleaning
cycle. The tangle-reducing swivel, in addition to
proper installation, general maintenance and the
following troubleshooting steps can help to avoid
cable challenges.
IMPORTANT
Cleaner power cable may become tangled if correct procedure is
not followed after each cleaning cycle.
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the
middle of the pool length. Only place enough
cable in the water to reach the farthest point in
the pool.
Not Recommended
Cleaner
Cleaner
Max Floating
Cable Length
Figure 6.
Optimal Entry Point in Pool
Page 14
Caddy /
Control Box
Recommended
Entry Point
WARNING
Do not use an extension cord.
Polaris
If tangling occurs, follow these steps:
1.
Remove the cleaner from the pool using the
Lift System. When the cleaner is within arm's
reach, use the handle to remove from the
water. Never lift the cleaner out of the pool by
the floating cable or swivel.
2.
Hold the cleaner vertically to drain.
Figure 7.
Keep Cleaner Vertical to Drain Water
3.
Unplug power to the cleaner at the control
box.
Figure 8.
Unplug
Robotic Pool Cleaner | Owner's Manual
®
Publicidad
