Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
Robotic Pool Cleaner | Owner's Manual
®
Control box receiving power
Start/Stop cleaning
Select cleaning mode
*
Waterline (45 min) Waterline only
Quick Clean (1 h 15 min) Floor only
SMART Cycle
(Calculate custom clean duration)
Floor, Wall, Waterline
Deep Clean (2 h 45 min)
*
Floor, Walls, Waterline, High Intensity
Dirty canister indicator
Remove cleaner from the pool
+ / - 15 minute increments
Initiate connection and set up
iAquaLink
®
Bluetooth
BLINKING - searching for signal
SOLID - paired with phone
Wi-Fi light indicator status:
BLINKING - connected to router
SOLID - connected to the internet
Set recurring cleaning:
*
Every: Day, 2 Days, or 3 Days
* not available on all models
control
light indicator status:
®
4.3
Start / Stop Cleaning and Adjust
Cleaning Time
The factory default cleaning mode is SMART Cycle
(Floor, Wall, Waterline).
The first use of SMART Cycle (duration: 2:30),
will automatically calculate the cleaner's optimal
cleaning time for your pool. After the initial SMART
Cycle calculation, the optimal cleaning time is
saved for future use.
To recalculate the SMART Cycle setting, press and
hold the START/STOP button for 5 seconds.
Use
to change cleaning surface setting.
Toggle between:
*
Waterline (45 min) Waterline only
Quick Clean (1 h 15 min) Floor only
SMART Cycle
(Calculate custom clean duration)
Floor, Wall, Waterline
Deep Clean (2 h 45 min)
*
Floor, Walls, Waterline, High Intensity
* not available on all models
1.
With cleaner submerged in water, press
to begin operation.
Press again to interrupt and cancel an
in-progress cleaning cycle.
NOTE: At the beginning of each cleaning cycle,
the robot confirms your pool parameters
(approximately 10 minutes). During this time, the
cleaner does not climb to the waterline.
Press +/- buttons to increase or decrease cleaning
time in 15-minute increments.
- Minimum run time is 30 minutes.
- Maximum run time is 3 hours 30 minutes.
NOTE: The control box automatically goes into standby
mode after 5 minutes and the display screen
turns off. Press any key to exit standby mode
and view remaining cycle time. Cleaner will
continue to function in standby mode.
ENGLISH
Page 9
Publicidad
