Bemer Therapy System Evo Instrucciones De Uso página 30

Idiomas disponibles

6.2.1 B.Light Clear Evo

An application module for complementary treatment of skin diseases, impaired wound healing,

and cosmetic use. The light-emitting diodes produce a red and blue light with a strong photobio-

logical effect. This results in additional formation of energy-rich compounds in the skin and

connective tissue cells. Complementary use of this module is recommended for acne.

Please continue treatment until the acne lesions subside and the skin appears healthy and supple.

If symptoms persist and / or excessive redness or discomfort occurs, a physician must be consulted

before continuing the therapy.

6.2.2 B.Light Restore Evo

The B.Light Restore Evo module is an application module for complementary treatment and tem-

porary relief of mild muscle and joint pain, arthritis and muscle spasms, and relief from stiffness.

It also promotes the relaxation of muscle tissue and temporarily boosts the local circulatory system.

In addition, it helps to reduce the appearance of wrinkles and fine lines.

Please continue treatment until the fine lines and wrinkles appear less pronounced and the

firmness and smoothness of the skin has improved. If symptoms persist and / or excessive redness

or discomfort occurs, a physician must be consulted before continuing the therapy.

7. Commissioning

7.1 Connecting the B.Box Evo Stand, Wall Mount, and Battery Stand

Take care to open the packaging of the BEMER Therapy System Evo in the correct place (see the

"Upside" symbol on the packaging) and ensure that the contents of the packaging cannot fall out

after opening. Having opened the packaging, first remove the B.Box Evo Stand or B.Box Evo Battery

Stand and connect it to the B.Box Evo controller. Connect the B.Box Evo Battery Stand (Premium

Set) or the B.Box Evo Stand (Basic Set) to the B.Box Evo. To do this, bring the B.Box Evo Battery

Stand close to the B.Box Evo as shown – the magnetic holder will then ensure a secure attachment.

Attaching the B.Box Evo Stand or the B.Box Evo Battery Stand

Before commissioning the B.Box Evo Battery Stand, the battery protection cover must be removed

from the B.Box Evo. To do this, use a Phillips screwdriver (PH 1) and be sure to replace the pro-

tective cover after removal of the B.Box Evo Battery Stand / B.Box Evo Stand. Keep the protective

cover in a safe place.

Note on battery operation

As long as the B.Box Evo is supplied with voltage, the B.Box Evo Battery Stand will be continuously

charged. The current charging status can be seen on the display. In addition, the green LED on the

top of the unit lights up.

Note on operation with the B.Box Evo Wall Mount

The B.Box Evo Wall Mount is attached to the desired location on the wall using the two included

screws (4.5 x 35 mm) and dowels. Ideally, the chosen mounting position should take account of the

length of the applicator cables (2.5 meters). If longer distances are required between the B.Box Evo

and the application modules, the extension cord for Evo applicators (optional accessory) can be used.