Descargar Imprimir esta página

Stihl RE 100.0 PLUS CONTROL Manual De Instrucciones página 37

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 46
8 Connecting the pressure washer to the power supply
Connecting the water filter
If the high-pressure washer is operated with
water containing sand from water butts, cisterns
or from flowing or still rivers and lakes, a water
filter must be connected to the high-pressure
washer.
Depending on the market, the water filter may be
included with the high-pressure washer.
2
1
3
► Unscrew the connector (1).
► Insert water intake screen (2) into the coupling
of the water hose (3).
Connecting the water hose
3
2
1
► Fill the water hose (1) with water so that no air
is present in the water hose any more.
► Screw the coupling (2) onto the connector of
the pressure washer (3) and tighten by hand.
► Attach the suction cup (4) to the water source
so that the suction cup (4) does not touch the
ground.
► If the spray gun is fitted to the high-pressure
hose: Remove the spray gun.
► Hold the high-pressure hose downwards.
► Switch on the high-pressure washer until an
even water jet flows out of the high-pressure
hose.
0458-004-9821-B
NOTICE
■ If the high-pressure washer does not suck in
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
8
8.1
1
4
► Set the toggle switch to the 0 position.
► Remove the connecting cord (2) from the hold‐
► Plug the plug of the connecting cord into a cor‐
9
9.1
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavorable
mains conditions. The voltage fluctuations may
negatively affect other connected electrical appli‐
ances.
water, the pump may run dry and the high-
pressure washer may be damaged.
► If no water escapes from the high-pressure
hose after two minutes: Switch off the high-
pressure washer and check the water sup‐
ply.
hose.
Connecting the pressure
washer to the power supply
Connecting the pressure
washer to an electric power
supply
3
2
3
ers (3).
rectly installed socket.
Switching the pressure
washer on and off
Switch on high-pressure
washer
English
1
37

Publicidad

loading