Publicidad
Idiomas disponibles
Idiomas disponibles
English
► Push the battery (2) into the charger (3) until it
stops.
The LED on the charger (4) glows green when
the battery is charging.
The LEDs (1) on the battery glow green and
show the state of charge.
The charging process is complete when the
LED on the charger and the LEDs on the bat‐
tery go out.
The charger turns itself off when the battery is
fully charged. The battery can be removed
from the charger.
► Disconnect the power supply cord from the
electrical outlet when the charger is not in use
for extended periods of time.
A battery is not fully charged when it ships from
the factory. STIHL recommends that you fully
charge the battery before using it the first time.
Operate the charger indoors in a dry room. For
optimum performance, observe the recommen‐
ded ambient temperature ranges,
The battery heats up during operation of the
hedge trimmer. If a hot battery is inserted into the
charger, it may be necessary for it to cool down
before charging starts. The charging process
begins only after the battery has cooled down
sufficiently.
Charging time depends on a number of factors,
including battery condition and ambient tempera‐
ture. For a complete list of approximate charging
times, see www.stihl.com/charging-times.
11.3
Mounting the Charger on a
Wall
Before mounting, ensure that no electrical
cables, pipes or other service lines run in the wall
behind the charger.
To mount the wall charger:
b
2
1
c
a
► Mount the charger indoors in a dry room near
an electrical outlet.
► Sink the screws into a wall stud. Use appropri‐
ate screw-in wall anchors or other similar
16
mounting devices if an appropriate wall stud is
not available.
► Align the charger as shown above. Mount to a
wall with the following dimensions:
– a = minimum 18 in. (450 mm)
– b = minimum 3.9 in. (100 mm)
– c (for AL 101) = 3.0 in. (75 mm)
– c (for AL 301) = 3.9 in. (100 mm)
– c (for AL 500) = 4.7 in. (120 mm)
– d = 0.2 in. (4.5 mm)
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2.5 mm)
12 LED Diagnostics
12.1
12.1.1
Four LEDs show the status of the battery. These
LEDs can glow or flash green or red.
24.6.
12.1.2
When the battery is inserted in the hedge trim‐
mer, the same LEDs on the battery will indicate
the status of the hedge trimmer.
If three LEDs glow red continuously: the hedge
trimmer motor is too hot. Allow the motor to cool
down.
If three LEDs flash red when you activate the
switch lever and trigger switch: the hedge trim‐
3
mer has an electrical malfunction. Do not operate
the hedge trimmer. Have it checked by an
authorized STIHL servicing dealer before use or
storage.
e
d
For troubleshooting information,
f
12.1.3
f
The LEDs on the battery also show the battery's
state of charge.
To determine the battery's state of charge:
12 LED Diagnostics
LEDs on the Battery
Battery Status
If one LED glows red continu‐
ously: the battery is either too
hot or too cold. Allow the battery
to warm up or cool down gradu‐
ally at an ambient temperature
of about 50 °F to 68 °F (10 °C to
20 °C).
If all 4 LEDs flash red: the bat‐
tery has a malfunction and must
be replaced. Do not attempt to
charge, use or store the battery.
Hedge Trimmer Status
Charge Status
23.1.
0458-019-8601-A
Publicidad
