Beem W929735 Manual De Instrucciones página 45

45
Problem
Water runs out of the
device.
The portafi lter (16)
cannot be inserted.
The espresso runs
along the outside of the
portafi lter (16).
Despite a pumping
noise, no water comes
out of the device.
The espresso does not
run or only runs very
slowly into the cup.
Possible cause
There is too much water in the
water tank (6).
The steam power control (8) is
not in the position.
The drip tray (13) is full.
There is too much espresso
powder in the portafi lter.
The portafi lter is not inserted
correctly.
The rim of the portafi lter
is contaminated with
espresso powder.
There is no water in the water
tank (6).
The water tank is inserted
incorrectly.
The espresso powder is pressed
too fi rmly.
The espresso powder is too
fi nely ground.
There is too much espresso
powder in the portafi lter (16).
The transport protection is still
attached to the water feed below
the water tank (6).
The sieve insert (17, 21) is
blocked.
The device is furred up.
Fix
Do not overfi ll the water tank!
Always move the selector switch
to the position when there is
no vessel under the portafi lter
outlet or the steam nozzle (9).
Empty the drip tray.
Add less espresso powder.
Make sure that it fi ts correctly.
Clean the portafi lter and the
sieve insert (17, 21).
Fill the water tank.
Take out the water tank and
reinsert it. Make sure that it fi ts
correctly.
Only press down the espresso
powder lightly.
Use espresso powder with a
coarser grind.
Add less espresso powder.
Pull out the orange / red plug
before you start operating the
device.
Clean the sieve insert, using the
cleaning needle (20) if necessary.
Descale the device.
EN