EN
Preparation
PLEASE NOTE!
•
Do not operate the device without water or with less water than is required to reach the
MIN marking.
•
Never use the device without a suitable cup below the portafi lter.
Making Espresso
1. Fill the water tank (6) (see the "Preparation" chapter – "Filling the Water Tank").
2. Make sure that the steam power control (8) is in the
3. Switch on the device by touching the fi eld
The fi eld
fl ashes slowly and the fi elds
Once the preheating has ended, all operating fi elds and the control lamp STEAM / HOT
WATER (27) light up. The device is ready to operate.
4. Prepare the portafi lter (16) for the espresso you want in the manner described in the
"Preparation" chapter and insert it into the device.
5. Place one or two suitable cup(s) on the storage plate (15) under the portafi lter.
With two cups make sure that they are each positioned next to each other below an outlet
under the portafi lter.
6. Touch the fi eld
process. The corresponding fi eld fl ashes. The set quantity of water runs through the portafi lter
into the cup(s). The device then automatically switches to standby mode. All fi elds and the
control lamp STEAM / HOT WATER light up.
7. Switch the device to sleep mode by touching the fi eld
fi eld
.
If there is no more action, the device automatically switches to sleep mode after approx.
30 minutes. All fi elds go out, apart from the fi eld
the fi eld
.
Preparing Milk Froth
1. Fill the water tank (6) (see the "Preparation" chapter – "Filling the Water Tank").
2. Direct the steam nozzle (9) towards the drip tray (13) or into an empty vessel.
3. Move the steam power control (8) to position
4. Switch on the device by touching the fi eld
The control lamp STEAM / HOT WATER (27) fl ashes.
(single espresso, 24) or
(Off) position.
(22). The device switches to preheating mode.
(30) and
(23) light up.
(double espresso, 26) to start the brewing
. All fi elds go out, apart from the
. To switch the device on again, touch
(Steam).
(22). The device switches to preheating mode.
38