Sears Kenmore 10937045 Manual De Uso Y Cuidado página 14

Refrigerador con montaje inferior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I'ii
U
Problem
Meat drawer or crisper
drawer does not close
freely
Solution
O
O
e
Refrigerator has an
odor.
Refrigerator'makes
It may be normal
See "Normal Operating Sounds" section,.
unfamifiar sounds or
seems too loud.
Ice cubes have an
odor
Ice cubes stick together
or "shrink".
ice maker (some
models) is not
producing ice
Ice maker' (some
models) is riot
producing enough ice,.
Ice forms in inlet tube to
ice maker (some
models).
Check for a package that may prevent drawer from closing properly,
Confirm drawer is in proper position
Clean drawer channels with warm, soapy water, Rinse and dry thoroughly
Apply a thin layer of petroleum jelly to drawer channels
Con[![m ' refrigerator is level.
See "Odor Removal" instructions in "Care and Cleaning" Section
See "Odor Removal" instructions in "Care and Cleaning" section
Ice maker (some models) was recently installed Discard first few batches of ice
to avoid discolored or off-flavored ice.
Food has not been wrapped tightly in either refrigerator or freezer compartment,
Rewrap foods since odors may migrate to the ice if food is not wrapped properly
Discard ice and clean ice bucket or trays more frequently, Ice cubes are porous
and absorb odors easily
Water supply contains minerals such as sulfur', In some situations a filter may
need to be installed to eliminate taste and odor problems.
Empty ice cube bucket or trays more frequently, If used infrequeni'l'y, ice cubes
may stick together or, sh,dnk.
Water pressure may be to low or high. Ice maker requires a water pressure of
20-120 psi to function properly
Confirm ice maker' arm is down See "Automatic Ice Maker" section,
Confirm household water supply is reaching water valve Make sure the water
valve shut off is fully turned on
o
Confirm ice maker wiring harness is inserted completely in proper holes,,
Check for kinks in copper or plastic tubing,. Remove kinks or replace tubing
Check electrical connections to water valve coil and connector block on
refrigerator cabinet
If a water filter' has been installed on the water line outside the refrigerator, check
the filter for clogs or improper installati,on of the fitter: .....
Ice maker has just recently been installed or a large amount of ice has just been
used,. Wait 24 hours for ice production to begin and for ice maker to restock after
emptied
Confirm household water supply is reaching water valve. Make sure the water
valve shut off is fully turned on
Piercing type or 3h_" saddle valve was used for hookup_ Both reduce water flow
and may become clogged with time. Replace these valves with correct type of
saddle valve requiring '/.," hole to be drilled in water supply pipe prior to valve
attachment,,
Check for kinks in copper or plastic tubing,. Remove kinks or replace tubing
Confirm freezer section is operating at proper temperature, Freezer must be cold
eno@roduce
ice. See 'Setting Controls" secti0n _ .....
Check water pressure
Low water pressure causes valves to leak.
14

Publicidad

Tabla de contenido
loading

Tabla de contenido