Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
Specifications
High voltages capable of causing severe injury or death by electrical
shock are present in this unit.
•
To reduce risk of electrical shock, disconnect power before working on or around the system. More than one disconnect
switch may be required to de-energize the equipment before servicing.
•
Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter (GFCI) device if
required by code.
•
Wire pump system for correct voltages.
•
Check local electrical and building codes before installation. The installation must be in accordance with their regulations
as well as the most recent National Electrical Code (NEC), Occupational Safety and Health Act (OSHA), and Canadian
Electrical Code (CEC).
•
This product is supplied with a grounding conductor and grounding-type attachment plug. To reduce risk of electric
shock, be certain that it is connected only to a properly grounded grounding-type receptacle. Do not remove the third
prong from the plug. The third prong is to ground the pump to help prevent possible electric shock hazard. Do not use an
extension cord.
•
Check electrical outlets with a circuit analyzer to ensure power, neutral, and ground wires are properly connected. If not,
a qualified, licensed electrician should correct the problem.
•
Be sure the electrical connection cannot be reached by rising water. Under no circumstances should the junction box be
located where it may become flooded or submerged by water.
Risk of bodily injury, electric shock, or equipment damage.
•
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in
experience and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with
the unit or in the immediate vicinity.
•
Do not use this pump for pumping any liquid intended for human consumption.
•
Equipment can start automatically. Always unplug the pump power cord and disconnect the electrical power before ser-
vicing the pump or switch. Lockout-Tagout before servicing equipment.
•
An inoperative or malfunctioning pump could lead to flooding, resulting in personal injury or property damage.
•
In applications where property damage and/or personal injury might result from an inoperative or leaking pump due to
power outages, discharge line blockage, or any other reason, an automatic back-up system and/or an alarm should be
installed.
•
Do not run the pump dry. If run dry, the surface temperature of the pump will rise to a high temperature that could cause
skin burns if touched, and will cause serious damage to the pump.
•
Do not oil the motor. The pump's motor housing is sealed, and contains a high-grade dielectric oil for heat transfer and
lifetime lubrication. Use of other oils could cause serious electric shock and/or permanent damage to the pump.
•
The pump has been evaluated for use with water only. Pump should only be used with liquids compatible with pump
component materials. If the pump is used with liquids incompatible with the pump components, the liquid can cause
failure to the electrical insulation system resulting in electrical shock.
•
Operation of this equipment requires detailed installation and operation instructions provided in this manual for use
with this product. Read entire manual before starting installation and operation. End User should receive and retain
manual for future use.
•
Keep safety labels clean and in good condition.
Risk of damage to pump or other equipment.
•
Do not use this pump for pumping sea water, beverages, acids, chemical solutions, or any other liquid that promotes cor-
rosion as this can result in damage to the pump.
•
Do not run pump dry. For optimal cooling and to prolong the motor life, the liquid level being pumped should normally be
above the top of the pump housing.
•
This pump is not suitable for pond applications.
2
Publicidad
