Harken BRS102/P Manual Del Usuario página 14

english
Never replace any part of the device with non-original Harken
may look similar. Replacements of non-original components will invalidate the warranty.
Harken shall not be liable for damage or injury caused by the incorrect installation of the
®
device and/or improper use of the system.
For more information, consult the website www.harken.com
INSTALLATION PROCEDURE
WARNING! Install the button on a flat surface.
NOTE: all of the following procedures apply to both the Harken BRS102 button
and the Harken BRS104 button, unless otherwise specified.
1. Wiring (procedure valid only for Harken BRS102 button)
Before proceeding to install the device, perform the button power supply wiring.
WARNING!
Cable size range: 0.34 – 1.5mm
Cable gland seal diameter range: Ø4.5 - Ø5.5mm
1.1 Loosen the cable gland on the button base
1.2 Remove the button top cover
10
info@solidworks.com
info@solidworks.com
(AWG: 22-16)
2
components, even if they
®