Harken BRS102/P Manual Del Usuario página 15

1.3 Loosen the button's internal contact sealing screws
1.4 Insert the two cables inside the button compartment by passing them through the
cable gland
1.5 Crimp each cable to the relevant terminal
1.6 Insert the terminals under the contact screw
1.7 Tighten the contact screws to fix the terminals
1.8 Slide a sheath along the cables, passing it through the cable gland: stop on the cable
passage useful area, without deforming them in any direction
info@solidworks.com
1.9 Screw the cable gland so that the seal of its gasket is watertight
WARNING! Before closing the button with the cover, make sure that the cables
info@solidworks.com
are well laid inside the button compartment and that they have not been
deformed
info@solidworks.com
english
11