Kemper MaxiFil Instrucciones De Servicio página 72

Pos. Description
1 Product
2 Control box mounting point
Extraction arm
length
2 m, 3 m, 4 m
5 m, 6 m, 7 m
7 m, 8 m
9 m, 10 m
7. At the installation location, determine the required mounting height of
the product according to the table. The required mounting height
depends on the extraction arm selected.
8. Drill the four bore holes according to the figure. Use a spirit level for
alignment.
9. Insert suitable fixing material into the bore holes so that the product
can be securely hooked onto the support points (Pos. 3).
10. Lift the pallet with the product using a suitable lifting tool and attach it
to the fixing material using the four support points.
11. Tighten the four fixing screws and make sure that the product is
securely held.
1502954-00
Tab. 26: Positions on the product
Note
With wall bracket art. no.: 9113004 3070
With cantilever 4 m, art. no.:
7911407
With cantilever 6 m, art. no.:
7911607
Tab. 27: Determining the mounting height
- 72 -
Pos. Description
3 Support points (product)
4 Fixing material (fixing
screws)
-
EN
A [mm]
2420
3310
3510