Publicidad
GB | Wireless Doorchime
The set consists of a push button of the chime (transmitter) and
door chime (receiver). The door chime is designed for permanent
installation to electrical network of 230 V/50 Hz voltage. Transfer
between the push button and the chime is ensured with the
help of airwaves of the frequency of 433,92 MHz and the radius
depends on local conditions and is as much as 60 m in open area
without interference.
Please read the Operating Manual carefully for a correct
operation of the wireless chime.
Technical specifications
Chime push button:
Power supply: battery 1× 3 V (CR2032)
Radius: up to 60 m in open space (in urban area it can get
reduced to one fifth or even less)
IP code: IP44
Chime:
Broadcast frequency: 433.92 MHz, 10 mW e.r.p. max.
Power supply: 230 V~/50 Hz
Number of chimes: 1
Pairing method: self-learning function
Possibility to pair more pushbuttons: yes (max 8)
Installation
Chime push button (transmitter)
1. Using appropriate screwdriver unscrew the little screw on
the bottom part of the button.
2. Screw down on to a wall the back cover using two screws
(not enclosed) or use double sided adhesive tape (also not
part of the package). Before starting the installation make
sure that the set works on the place you have selected in
a smooth and reliable manner. Despite the push button
being resistant against weather conditions it is better to
S2
CR2032
use appropriate position, so the button is protected e.g.
place it in a niche.
3. Open the battery box cover. Following the scheme under the
contacts insert battery 3 V, type CR2032. Pay attention to
correct polarity of inserted batteries!
4. Reassembly the push button and secure it with the screw.
5. Press the button. The press is accompanied by a gleam of
red LED diode which signalizes that the push button trans-
mitted radio signal.
6. If the red panel light on the push button does not light up
the battery is low and it is necessary to replace it. The push
button battery holds for one year of operation. The period
can vary depending on frequency and conditions of usage.
Important notice:
The push button (transmitter) can be installed on to wooden or
brick walls without any problem. However, never place the push
button directly on to metal surfaces or materials containing metal
such as plastic constructions of windows and doors with metal
frame. The transmitter may not function correctly.
Starting up
1. Connect the bell to an electric network. A green LED diode
will light up in the front side of the bell permanently and a
chime will sound once. Then the bell is ready to be matched.
2. Push the ringing button on the pushbutton (transmitter).
A chime will sound and the pushbutton will be matched.
3. To match other pushbuttons, repeat the procedure according
to point 2.
4. Pushbuttons can be matched within 25 seconds from insert-
ing the bell into a power socket.
5. If you want to match other pushbuttons later, proceed
according to point 1 and 2.
6. You can match a maximum of 8 pushbuttons this way.
Note: If you match another pushbutton (9th and more), the
memory of the first pushbuttons will be erased automatically
in reverse order.
2
2×
Publicidad
