Stihl iMOW 5.0 EVO Manual De Instrucciones página 72

English
8.10 Confined section
1
1
The robot mower navigates all confined areas,
provided that a minimum width (a) is maintained
between the perimeter wires (1).
► Route the perimeter wire (1) as illustrated and
make sure that the following dimensions have
been maintained:
– Minimum distance between the perimeter
wires (1) in the confined section: a = 2 m
– If the confined section is restricted by side
obstacles: Include an additional distance of
b = 37 cm (length: 1x iMOW
► If the minimum distance a = 2 m between the
perimeter wires (1) cannot be maintained:
Route a guide wire through the middle of the
confined section.
Confined section with guide wire
1
2
1
1
2
1
A guide wire (2) directs the robot mower through
the confined area, provided that a minimum
width (a) is maintained between the perimeter
wires (1).
On completing commissioning, it is mandatory to
place a starting point (3) behind the confined
section and the starting point's approach fre‐
quency. Otherwise, the robot mower will not find
72
b
a
b
®
Ruler)
3
b
a
b
8 Installing the Perimeter Wire
its way through the confined section. Starting
points can be set using the MYiMOW
► Route the perimeter wire (1) as illustrated and
make sure that the following dimensions have
been maintained:
– Minimum distance between the perimeter
wires (1) in the confined section: a = 55 cm
– If the confined section is restricted by side
obstacles: Include an additional distance of
b = 37 cm (length: 1x iMOW
► Route the guide wire (2) in the middle of the
confined section.
► If the side distance b = 37 cm (length:
®
1x iMOW Ruler) is not possible: Install a cor‐
ridor to be able to guide the robot mower to
another mowing area
confined section from the mowing area.
8.11 Corridor
2
A
Use a corridor (1) to overcome confined sections
in a precise way or to define passageways.
– A corridor (1) connects the main mowing
area (A) with another mowing area (B).
– A guide wire (2) must be installed in a corridor
(1).
– There is no mowing within a corridor (1).
– A corridor must have a minimum width of
a = 55 cm between the perimeter wires.
► If the confined section is restricted by side
obstacles: Include an additional minimum dis‐
tance of b = 15 cm
On completing commissioning, it is mandatory to
place a starting point (3) behind the corridor (1)
and the starting point's approach frequency. Oth‐
erwise, the robot mower will not find its way from
®
app.
®
Ruler)
8.11 or block off the
1
3
B
b
a
b
0458-012-9801-A