Descargar Imprimir esta página

Craftsman 580.752360 Manual Del Operador página 10

Ocultar thumbs Ver también para 580.752360:

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Move throttle lever (A) to "Fast" position, shown as a
rabbit.
A
10. Move choke lever (B) to "Closed" position.
B
NOTE: For a warm engine, be sure the choke lever is in the
"Open" position.
11. Move engine switch (C) to "On" position.
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
All manuals and user guides at all-guides.com
12. When starting engine, position yourself as
C
C
OFF
• NEVER pull starter cord without first relieving spray gun
• When starting engine, pull cord slowly until resistance is felt
• After each starting attempt, where engine fails to run, always
• Firmly grasp spray gun with both hands when using high
ON
13. Return recoil starter slowly. DO NOT let rope "snap
14. When engine starts, slowly move choke lever to "Open"
15. If engine fires, but does not continue to run,always point
16. If engine fails to start after six pulls, move choke lever to
NOTE: Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
10
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
pressure.
and then pull rapidly to avoid kickback.
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
pressure spray to avoid injury when spray gun kicks back.
back" against starter.
position as engine warms. If engine falters, move choke
lever to "Closed" position, then to "Open" position.
gun in safe direction, press red botton and squeeze spray
gun trigger to release high pressure. Move choke lever to
"Open" position, and repeat steps 12 through 14.
"Open" position, and repeat steps 12 through 14.

Publicidad

loading