Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Hose and Water Supply to Pump
NOTE: Remove and discard the shipping caps from the pump's
high pressure outlet and water inlet before attaching hoses.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
1. Uncoil high pressure hose and attach quick connect end
of hose to base of spray gun. Pull down on collar of
quick connect, slide onto spray gun and let go of collar.
Tug on hose to be sure of tight connection.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to spray tip extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, spray tips and accessories are
correctly attached.
2. Similarly, attach other end of high pressure hose to high
pressure outlet (A) on pump. Pull down on collar of
quick connect, slide onto pump and let go of collar. Pull
on hose to be sure of tight connection.
B
3. Before connecting garden hose to water inlet, inspect
inlet screen (B). Clean screen if it contains debris or have
it replaced if damaged. DO NOT run pressure washer if
inlet screen is damaged or missing.
All manuals and user guides at all-guides.com
4. Run water through garden hose for 30 seconds to clean
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
• Damage to equipment resulting from failure to follow this
5. Connect garden hose (not to exceed 50 feet in length) to
• Always wear safety goggles when using this equipment or in
• Before starting the pressure washer, be sure you are wearing
• NEVER substitute safety glasses for safety goggles.
6. Turn ON the water, press red button (C) on the gun and
Checklist Before Starting Engine
Review the assembled unit to ensure you have performed all
of the following:
1. Be sure to read Safety Rules and How To Use Pressure
2. Make sure handle is in place and secure.
3. Make sure shipping cap was removed and oil dipstick
A
4. Check that oil has been added to proper level in engine
5. Add proper fuel to fuel tank.
6. Check for properly attached hose connections.
7. Check to make sure there are no kinks, cuts, or damage
8. Provide a proper water supply at an adequate flow.
8
out any debris. Turn off water.
NOTICE
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
instruction will void warranty.
water inlet.Tighten by hand.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
vicinity of where equipment is in use.
adequate safety goggles.
squeeze the trigger to purge the pump system of air and
impurities.
C
Washer before using pressure washer.
was installed in pump.
crankcase.
to high pressure hose.
Publicidad
