Publicidad
Idiomas disponibles
Idiomas disponibles
Change Engine Oil
While engine is still warm, drain oil from crankcase. Refill
with recommended grade. See Changing Engine Oil.
Oil Cylinder Bore
•
Remove spark plug. Squirt about 1 tablespoon of clean
engine oil into the cylinder. Cover spark plug hole with
rag. Pull recoil handle slowly to distribute oil. Avoid spray
from spark plug hole.
•
Install spark plug. DO NOT connect spark plug wire.
Protect Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump. This prevents freeze damage and lubricates pistons
and seals.
NOTICE
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
All manuals and user guides at all-guides.com
NOTE: PumpSaver is available as an optional accessory. It is
not included with the pressure washer. Contact your local
Sears service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Read and follow all
instructions and warnings given on the PumpSaver container.
Other Storage Tips
1. DO NOT store fuel from one season to another unless it
2. Replace fuel container if it starts to rust. Rust and/or dirt
3. Cover unit with a suitable protective cover that does not
• DO NOT place a storage cover over a hot pressure washer.
• Let equipment cool for a sufficient time before placing the
4. Store unit in a clean and dry area.
22
has been treated as described in Protect Fuel System.
in fuel can cause problems if it's used with this unit.
retain moisture.
WARNING
Storage covers can be flammable.
cover on the equipment.
Publicidad
