a) Make sure that the blades do not rotate when the
engine is at idle speed.
b) Increase the engine speed and make sure that
the blades start to rotate.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the engine manual that is supplied by the
engine manufacturer.
•
Do a check of the safety devices on the product.
Safety devices on the product on page 7 .
Refer to
•
Do the daily maintenance. Refer to
schedule on page 15 .
To adjust the handle height
•
Loosen the handle adjustment lever. Move the
handle up or down to an applicable height and
tighten the handle adjustment lever.
To install the floating disc
1. Put the floating disc on a hard flat surface.
2. Put the product on top of the floating disc.
3. Align the center of the blade assembly with the
center of the floating disc.
4. Turn the floating disc until the blades engage in the
brackets on the floating disc.
CAUTION:
floating disc is correctly installed before
you operate the product. An incorrectly
installed floating disc does not give a
smooth result.
12
Operation
Read and understand the
Maintenance
Make sure that the
3. Do a check of the gyroscopic safety switch. Refer
To do a check of the gyroscopic safety switch on
to
page 8 .
To start the product
1. Open the fuel valve.
2. Set the throttle control to idle speed.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
1452 - 003 - 30.01.2023