Husqvarna CT 36A/A-V Manual De Usuario página 16

Maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Do a check of the fuel level and the engine oil level.
Clean the cooling fins of the engine.
Make sure that the throttle control and the blade pitch
®
knob or Pro-Shift lever can move smoothly.
Clean the air filter.
Lubricate the blade shafts.
Lubricate the blade pitch cable and other parts of the
product.
Replace the engine oil.
Replace the air filter.
Do a check of the engine speed.
Do a check of the oil level in the gearbox.
Examine the belt for damage and replace if necessary.
Examine and clean the spark plug. Replace the spark
plug if it is necessary.
Clean the fuel valve on the carburetor.
Clean the spark arrestor screen on the muffler.
Clean the sediment cup.
Drain the fuel and clean the fuel tank and the fuel filter.
Clean and adjust the carburetor.
To clean the product
CAUTION:
washer to clean the product.
• Use water and a brush to clean the product.
CAUTION:
directly at the fuel tank cap, electrical
components or the engine.
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
• Remove grease and oil from the handle.
16
Do not use a high-pressure
Do not point the water
Before use, After the
each 10 h first 20 h
*
X
*
X
O
*
X X
X X
X
O
To do a check of the engine oil level
1. Remove the oil tank cap and dipstick.
2. Clean the oil from the dipstick.
3. Put the dipstick back fully into the oil tank.
4. Remove the dipstick.
5. Examine the oil level on the dipstick.
6. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 25 or the engine manual for the correct
type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
Monthly, Yearly, each
each 200 h 500 h
O
*
X X
X
O
X X
X
O
O
O
O
O
O
Technical data
1452 - 003 - 30.01.2023