Descargar Imprimir esta página

Husqvarna CT 36A/A-V Manual De Usuario página 19

Ocultar thumbs Ver también para CT 36A/A-V:

Publicidad

Idiomas disponibles

Idiomas disponibles

a) Make sure that the blades are installed in the
correct position related to how they rotate, as
shown in the illustration.
b) Attach the blades with washers and the
lubricated screws (A). Torque the screws to 26
Nm/19 lb-ft.
B
1452 - 003 - 30.01.2023
A
A
4. Put plastic plugs (B) in the remaining holes in the
blades. This is to make sure that the holes are not
filled with concrete during operation.
Gearbox
It is not necessary to do regular maintenance on the
gearbox other than a check of the oil level. If there is
a leakage or other problems with the gearbox, let an
approved service center repair the product.
To do a check of the oil level in the
gearbox
1. Put the product on level ground.
2. Look through the plug at the side of the gearbox.
The oil level is correct if it is at the bottom of the plug
threads.
3. If the oil level is too low, fill with oil to the correct
Technical data on page 25 for the
level. Refer to
recommended oil type.
19

Publicidad

loading

Este manual también es adecuado para:

Ct 48a/a-v