DynaTrap DT2000XLP Manual Del Propietário

DT2000XLP
OWNER'S MANUAL
Thank you for purchasing
the DYNATRAP ® Insect Trap!
This product may be covered by one or more U.S. patents
or pending patent applications. See www.DynaTrap.com/patents
IMPORTANT: READ CAREFULLY
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING:
when using electric appliances, basic precautions should
always be followed, including the following:
1. Please read all instructions before using the DynaTrap Insect Trap and keep for future reference.
®
2. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet.
3. To reduce the risk of injury from moving parts or electric shock, always turn unit off and disconnect plug before
servicing or cleaning.
4. Always unplug before replacing lamp. Replace with same type rated 6-Watt bulbs, DynaTrap
5. Do not position the unit near heat, gas, oil or other flammable materials.
6. Place out of reach from children.
7. To reduce the risk of electrical shock, do not put appliance in water or other liquid.
8. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or if it has been dropped into water or other liquid.
9. Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
10. Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
11. Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
12. Do not clean this product with water spray. Do not place where it can fall into water, or near flammable materials.
13. Do not touch fan while in motion.
14. Do not abuse cord—never carry or hang unit by cord or yank it to disconnect from receptacle. Keep cord away
from sharp edges.
15. If using outdoors, use only extension cords with a tag stating, "Suitable for Use with Outdoor Appliances."
16. Use only extension cords that have plug and receptacles that match the product plug. Replace or repair damaged cords.
17. Only use attachments recommended or sold by the manufacturer.
18. This appliance is provided with double insulation. Use only identical replacement parts. See instructions or
Servicing of Double-Insulated Appliances.
INSTALLATION & OPERATING INSTRUCTIONS
1. Unpack unit. Save carton for off-season storage (if needed). Remove cardboard insert from the retaining cage.
2. Place the air damper assembly in the retaining cage with the crossbar facing up. Align the six damper notches with
the matching notches on the retaining cage.
3. Place the trap on the retaining cage and twist clockwise to the lock position.
4. If hanging the unit, place it approximately 3 - 6 feet above floor or ground for optimal catch-rate and easy access
for cleaning. Unit can also be placed on the floor or ground.
5. Flip power switch to "ON" ("I") position. The switch is located under the upper housing near the light bulbs.
6. For best catch results, leave unit on at all times, except when cleaning or servicing.
7. Catch rate activity will be higher at night. For best catch results, place unit away from other competing light sources.
8. It is recommended to place the unit 20 - 40 feet away from where people will be sitting.
9. This unit is all-weather resistant – designed for outdoor use including rainy conditions. Intended for household and
commercial, indoor and outdoor use.
10. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug
in any way.
11. SERVICING OF DOUBLE-INSULATED APPLIANCES - In a double-insulated
appliance, two systems of insulation are provided instead of grounding.
No grounding means is provided on a double-insulated appliance, nor
should a means for grounding be added to the appliance. Servicing of
a double-insulated appliance requires extreme care and knowledge
of the system and should be done only by qualified service personnel.
Replacement parts for a double-insulated appliance must be identical
to those parts in the appliance. The symbol must be identical to those
parts in the appliance. A double-insulated appliance is marked with the
words "DOUBLE INSULATION", "DOUBLE-INSULATED" or the symbol:
FCC COMPLIANCE
This device complies with part 18 of the FCC rules. This product may
cause interference to radio equipment and should not be installed
near maritime safety communications equipment or other critical
navigation or communication equipment operating between 0.45-30 MHz. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CLEANING
Frequent cleaning will prolong the life of the unit, ensure fire prevention and provide for more efficient operation.
® model 32050. 1. Remove the retaining cage by holding the trap securely and twisting counterclockwise.
2. Grasp the edge of the crossbar and pull up firmly to remove damper assembly.
3. Dispose of contents and clean any buildup from the inside of the retaining cage with a small brush.
4. Attach the air damper assembly to retaining cage and reattach to trap with a clockwise twist to the lock position.
5. Clean before off-season storage. IMPORTANT: DO NOT press or push against the screen windows while cleaning or
assembling.
REPLACING BULBS REPLACE WITH DYNATRAP
The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly to
ensure optimal UV effectiveness. Even though the bulb's light may be visible to you, it's ability to attract insects diminishes
over time.
1. Turn power switch to "OFF" ("0") position. UNPLUG UNIT (1), and allow bulbs to cool before replacing.
2. Remove screw from clear plastic light socket covers (2).
3. Remove both clear plastic light socket covers.
4. Carefully turn bulb counterclockwise and then pull bulb straight out (3).
5. Locate and insert new bulbs into sockets, carefully turn clockwise, and make sure the prongs of the bulb
are seated properly.
6. Replace clear plastic light socket covers and secure with screw.
® BULBS #32050 (or equivalent T5 Type - 120V/6W UVA Bulbs)
HOW THE DYNATRAP ®
INSECT TRAP WORKS
Flying insects are attracted to the unit by the
UV light and CO2 that is generated by the
photo-catalysis between the UV lamps and
the special TiO2 coating. The fan then pulls
the insects into the screened base, trapping
them until they dehydrate and die. The base
can be removed, allowing the contents to be
periodically emptied into the trash. Monitor
the insects trapped in the retaining cage,
through the see-through screen, and empty
when compartment becomes full.
TROUBLESHOOTING
Problem: Possible cause: Correction:
Bulbs do not illuminate No electrical power. 1. Check plug, receptacle, and fuse or circuit breaker.
and fan does not spin.
Bulbs illuminate, but fan Shorted fan. 1. UNPLUG UNIT: Examine fan to see that it is free from
does not spin. foreign material, dirt or buildup of dead insects.
2. Clean unit as in "CLEANING" section.
Fan spins, but bulbs do 1. Bulbs not seated 1. Check all sockets for proper bulb seating and alignment.
not illuminate. properly. 2. Replace bulbs if needed following instructions under
2. Burnt out bulbs. "Replacing Bulbs."
LIMITED WARRANTY
DYNAMIC guarantees to the original purchaser that this product is free from defective materials and
workmanship. This warranty is limited to remedy any defective part for a period of one year from date of
original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply to
the light bulb, nor to, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in force.
This warranty does not apply if this unit is purchased outside the United States, Canada and Mexico. In no case
shall DYNAMIC be liable for any accidental, punitive, consequential, or any other damages of any kind for
breach of this or any other warranty, expressed or implied, whatsoever. Some states do not allow limitation on
how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. This warranty
gives you specific legal rights, and you may also have other rights that vary from state to state.
REPLACEMENT PARTS
32050 2, 6-Watt UV Replacement Bulbs
To see all replacement and accessory parts available for your DynaTrap, visit www.DynaTrap.com.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD AND COMMERCIAL,
INDOOR AND OUTDOOR USE
Dynamic Solutions Worldwide, LLC
69 N. Locust St., Lititz, PA 17543
1-877-403-8727 (TRAP)
dynatrap@woodstream.freshdesk.com
www.DynaTrap.com
This device complies with Performance Standards
for Light-Emitting Products, 21 CFR, Part 1040,
© Dynamic Solutions Worldwide, LLC
Chapter 1, Subchapter J, Radiological health.
120 V~ 60 Hz 35 W