Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BATTERIES
NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
A er removing the drawer, push the ba ery cover
locking tab with a screwdriver to release the cover.
Install the (4) AA alkaline ba eries as shown.
Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
NOTE: If the ba eries are low the combination
bu ons will ash red when pushed. Replace with
4 new AA alkaline ba eries as shown.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
• For security you must program your own
combination a er opening the safe.
• Record your new combination on this form
or store your combination on our secure
website at stack-on.com under Customer
Service. If you write down your combination
you must keep this information in a secure
place, away from children, not inside the safe.
1.
Press the Reset Bu on (3) located inside the safe.
Two "beeps" will sound (if the sound is turned
on) and all 3 bu ons will ash blue twice. You
will have 5 seconds to begin entering your
combination or you will have to start over.
2.
Enter your own 3-8 bu on combination by
pressing any combination of the 3 bu ons.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
For each combination entry a "beep" will sound
(if the sound is turned on) and all the bu ons
will light up green. If you delay more than 5
seconds between entries you will have to start
over from step 1. A er you have nished
entering your combination, you will have 5
seconds to press the Reset Bu on to record
your new combination or you will have to start
over from step 1.
3. When you press the Reset Bu on to record
your new combination, there will be two
"beeps" (if the sound is turned on) and all 3
keys ash blue twice, indicating your new
combination has been recorded.
Reset Button
3
14
40706-1608
Publicidad
