Publicidad
Idiomas disponibles
Idiomas disponibles
1.
(
#%$(/
+.. '-/#' (- 0 (1' %
&)
(+ ( ' 2/
This symbol on the device or the package indicates that disposal of the device
after its lifecycle could harm the environment. Do not dispose of the unit (or
batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling. This device should be returned to your distributor or to a
local recycling service. Respect the local environmental rules.
0 / # %3(4 $
(+$( * % . $+. "+-(' #/-) -+. +%(1
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this
device into service. If the device was damaged in transit, don't install or use it and contact
your dealer.
2.
+0'(*
-( %$(/
• Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
• Switch off and disconnect the mixer from the mains prior to connection to the amplifier
and other devices.
• Avoid using excessively long cables. Make sure all plugs and jacks are in perfect
working order to avoid hum, noise and pops that could damage speakers.
• Never use spray cleaners on knobs and sliders. Clean the mixer regularly using a dry
and clean cloth.
• There are no userDserviceable parts. Opening the mixer will void the warranty.
• Keep this device away from rain and moisture. Never place beverages on top of the
mixer.
3.
' ' +.
%/#'./ '-
• Use highDquality shielded cables with low capacitance throughout the system.
• Route one cable at the time. Pay attention to the labelled audio input and output jacks.
• Always begin with the master faders, volume controls and the amplifier volume at
minimum position. Gradually turn up the volume after connection is completed.
• Use the controls with restraint. Rapid movements may damage the speakers due to
amplifier clipping.
4.
-(+..+(/
Connect all stereo input sources, microphone and headphones. Make sure all faders and
volume controls are set to 0. Finally, connect all stereo outputs to the power amplifier
and/or tape decks. Plug the mixer to the mains using the power cord.
NOTE: Use the RCA connections with lowDcapacitance stereo cables.
5.
'-$ /)(/
1.
5 6
3Dpin XLR connection for microphones.
2.
Level controls (high, mid and low) for the DJ signal (+10 dB ~ D30 dB).
!
"
# $%&' ( )
PROMIX400SF2
-' &+ %+.
)'+
&' (+. / 0
&+(/
-
5
)' (* +&', (22/07/2008)
/
+3 %( (1/- )
3
#%$(
/(/'-,
HQPOWER
Publicidad
