Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the dispenser/ ejection timing
When the plant falls into the ploughshare (C), the ejector
(B) should be in the rear position and should then start
pushing the plant to eject it.
UN41 0181MG
Proceed as outlined below.
1) Slide out the plug (A).
2) Remove the cover (D).
3) Loosen the screws (E).
4) Turn the dispenser clockwise to speed up the ejec-
English language
ADJUSTMENT INFORMATION
B
C
If the conditions allow high- or low-speed planting, cor-
rect timing between the dispenser and the ejector can
be maintained by adjusting the dispenser.
tor's pushing action or rotate the dispenser anticlock-
wise to delay the pushing action.
The notches on the dispenser allow accurate timing
adjustment.
5) Tighten the screws (E).
6) Place the cover (D) on the dispenser.
7) Insert the plug (A).
23
5
D
A
E
Use and maintenance
Publicidad
