Publicidad
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
In case an adverse event occurred in relation to the device, it should be reported to your local dealer
and the national competent authority in a timely manner. The local dealer will forward information to
manufacturer.
Caregiver
• Read the "User Guide" carefully before use
and keep it for future reference. Incorrect
use of this product may cause serious
injury to the user.
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children.
• Always use the correct lifting techniques
and aids for this purpose.
• Ensure the stability of the product is main-
tained before placing the user in it.
• This product contains small parts which
could present a choking hazard if removed
from their intended placing.
• Never leave the user unattended in this
product. Ensure permanent supervision by
a caregiver.
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier.
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible.
• Ensure that moving parts do not squeeze
or trap body parts when adjusting them.
• Ensure that body parts are not trapped in
openings for mounting of supports/acces-
sories.
• Be careful not to get body parts trapped,
when placing the product over the toilet.
• Activate the brakes before placing the user
into the product.
• The user must not occupy the product
when it is lifted from the ground.
• All gassprings are to be kept locked, when
the device is not being adjusted.
• Be aware of any MAX mark indications
before adjustment.
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat or cold.
If the surface temperature is above 41°C
EN
then allow the product to cool before use.
• For the purpose of safety and comfort, al-
ways check the water temperature before
bathing the user.
User
• If the user is close to the max. load limit
and/or has a lot of involuntary move-
ments, e.g. rocking, a larger size with
a higher max. load or a different R82
product should be considered.
• When changing user, clean the product
and disinfect it if necessary. Carry out
necessary adjustments after cleaning.
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children.
• Ensure the stability of the product is main-
tained before placing the user in it.
• Unoccupied device is suitable for land and
air transport.
• The device is only designed to travel short
distances within the same room.
• Resistance to ignition is not claimed for
this product.
• The product might change its resistance to
ignition characteristics if using other than
original R82: Cushions.
21
etac.com
Publicidad
