Publicidad
Idiomas disponibles
Idiomas disponibles
IF THE PRODUCT IS DROPPED, SUFFERS HEAVY IMPACT OR BEGINS
TO VIBRATE ABNORMALLY, IMMEDIATELY STOP THE PRODUCT AND
INSPECT FOR DAMAGE OR IDENTIFY THE CAUSE OF THE VIBRATION.
ANY DAMAGE SHOULD BE PROPERLY REPAIRED OR REPLACE BY AN
AUTHORIZED SERVICE CENTRE.
• TO REDUCE THE RISK OF INJURY ASSOCIATED WITH CONTACTING ROTATING
PARTS, ALWAYS STOP THE MACHINE AND MAKE SURE ALL MOVING PARTS
HAVE STOPPED:
- BEFORE CLEANING OR CLEARING A BLOCKAGE
- WHEN LEAVING THE PRODUCT UNATTENDED
General operation : illustration 4.1 to 4.9
When older hedges are to be cut back a substantial amount, use pruning shears or some other
device to trim thicker branches (greater than 8 mm diameter) to the desired length before
starting work with the grass shear. To shape precisely, run a taught line between the extreme
edges of the hedge and then trim along the length of the line. Ensure that the blade does not
come into contact with any object made of hard material that could damage it, such as fencing
wire or metallic plant supports.
Cutting tips
1. Shaping
The hedge should be trimmed to achieve a trapezoidal form, it should widen toward the
bottom at both sides. This improves the penetration of light to the lower extremities. A general
guideline is approximately 10cm slant for each 1 meter of hedge height.
2. Cutting sequence
First cut both sides, starting at the bottom and working to the top: this prevents cuttings from
falling into the area where you are still to work.
3. Trimming the top
Where the branches have grown extremely long, cut back the hedge in several stages. The
shorter cuttings obtained are better suited for composting.
After use
Switch the product off and let it cool down.
Check, clean and store the product as described below.
5.
TRANSPORTATION
Transporting the machine may require that you meet certain requirements specific to your
country. Please make sure to respect them by contacting the authorities of your country,
in order to respect them all. Ensure temperature during transportation will never be out of
temperature range given on chapter storage
5.1 TRANSPORT THE MACHINE
Switch the product off and fully charge the battery. Attach the blade sheath. Protect the product
from any heavy impact or strong vibrations which may occur during transportation in vehicles.
Secure the product to prevent it from slipping or falling over.
- BEFORE INSTALLING OR REMOVING ATTACHMENTS
- BEFORE CHECKING, MAINTAINING OR WORKING ON THE PRODUCT
- IF THE MACHINE STARTS TO VIBRATE ABNORMALLY (INSPECT
IMMEDIATELY)
STRIKING A FOREIGN OBJECT TO INSPECT THE MACHINE FOR DAMAGE,
223
FR
ES
PT
IT
EL
- AFTER
PL
RU
KZ
UA
RO
EN
Publicidad
