universalblue UBE2401-20 Manual De Instrucciones página 42

• If you don't select a heat zone within 1 minute, the induction hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
• If slide along the "—", power will vary from stage 2 to stage 8.
• Press "-", power will decrease by one stage each time till stage 0.
• Press "+", power will increase by one stage each time till stage 9.
If the display flashes alternately with the heat setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed on it.
When you have finished cooking
• Touching the heating zone selection
• control that you wish to switch off.
• Turn the cooking zone off by touching the "-"and scrolling down to "0".
• Or slide along the "—" to the left point, and then touch the "-".
• Or touch the left point of "—", and then touching the "-".
Make sure the power display shows "0", then shows "H".
and then
• Turn the whole cooktop off by touching the ON/OFF control.
42