Dräger X-plore ADF 5-13 Instrucciones De Uso página 13

3.2 Operating unit
Illustration on the fold-out page (figure B)
1 Control dial for darkening
stage (weld mode)
2 Switch for darkening range
3 Switch position for darkening
range 9–13
4 Switch position for darkening
range 5-9
3.3 Adjustment options
Illustration on the fold-out page (figure C)
1 Adjusting screw
2 Setting for pivoting angle of
the visor
3 Setting for distance between
ADF and face
3.4 ADF (automatic welding protection filter)
Illustration on the fold-out page (figure D)
1 Photosensor
2 Liquid crystal display
3 Solar cell
4 Control dial for delay time from
dark to light
Instructions for use |
Dräger X-plore
5 Switch for grind/weld mode
6 Switch position for weld mode
7 Switch position for grind mode
4 Adjusting wheel (adjustment of
head circumference)
5 Quick adjustment system (adjust-
ment of height of the head)
5 Control dial for light sensitivity
6 Display for low battery charge sta-
tus
7 Display for grind mode
®
Welding Visor with ADF 5-13
3.5 Feature description
®1)
The Dräger X-plore 8000 protective welding visor with ADF 5–13 is designed
as both a facepiece and eye and face protector. The protective welding visor
protects its wearer from sparks and splashes as well as from harmful light rays
that occur during welding.
3.6 Intended use
The protective welding visor is designed for use with the powered air purifying
respirators from the Dräger X-plore
®
apparatus Dräger X-plore 9300. In the USA the Dräger X-plore
protective welding visor is only permitted to be used with Dräger X-plore
powered air purifying respirators.
Suitability for welding processes, see chapter 11 Annex.
3.7 Limitations on use
– The protective effect can be impaired by the following factors:
– High wind velocities and strong crosswind
– Earpieces or beards under the face cuff
– The ADF is not indestructible. It does not protect its wearer from danger
from heavy impact, e.g. from chipped grinding discs and explosive bodies or
from corrosive fluids.
– The protective welding visor is not suitable for work performed above head
height, laser welding or laser cutting work.
3.8 Approvals
For information on the corresponding system approvals please refer to the
instructions for use of the respirators mentioned in 3.6 Intended use.
The welding protective visors fulfil the following regulations:
– (EU) 2016/425
– Regulation 2016/425 on personal protective equipment, as amended to
apply in GB
®
1) X-plore is a registered trademark of Dräger.
Description
®
8000 series and the air line breathing
®
8000
| en
®
8000
13