Descargar Imprimir esta página

Dräger X-plore ADF 5-13 Instrucciones De Uso página 16

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27
en
|
Troubleshooting
5
Troubleshooting
Fault
Cause
ADF flickering.
Charge status of the bat-
teries is low.
ADF will not darken in a
Too little ambient light.
dark environment.
6
Maintenance
6.1
Cleaning and disinfecting
CAUTION
Potential damage to component parts!
► For cleaning and disinfecting only apply the described procedures and use
the specified cleaning agents and disinfectants. Other agents and
procedures, dosages and exposure times can damage component parts.
CAUTION
Health hazard!
The agents are harmful to health if they come into direct contact with eyes or
skin.
► Wear goggles and protective gloves when working with these agents.
For information on the appropriate cleaning and disinfecting
agents and how to use them, please refer to document 9100081
on www.draeger.com/IFU.
1. Remove textiles (head cover with face cuff and sweatband).
2. Prepare a cleaning solution containing water and a cleaning agent.
3. Clean textiles with cleaning solution.
4. To disinfect textiles:
a. Prepare a disinfectant bath of water and a disinfecting agent.
16
b. Place textiles in the disinfectant solution.
5. Carefully rinse textiles under running water.
Remedy
6. Allow textiles to dry in the open air or in a drying closet (temperature: max.
60 °C). Do not expose to direct sunlight.
Replace batteries (see
7. Clean the protective visor with a damp cloth.
figure G on page 2).
Set the control dial for
6.2
light sensitivity to HI
position (maximum light
Maintenance work
sensitivity).
Replacing the ADF
Replacing the external protective
screen
Replacing the internal protective
screen
Replacing the sweatband
Replacing the batteries
Removing the visor or support ring
Replacing the head cover with face
cuff
7
Transport the product in its original packaging.
8
Store the protective visor dry and clean in the original packaging and protect it
from direct sunlight and thermal radiation.
Instructions for use
Maintenance work
Illustration on fold-out page
Figures A, B, C
Figure B
Figure D
Figure E, F
Figure G
Figure H
Figure I
Transport
Storage
®
|
Dräger X-plore
Welding Visor with ADF 5-13

Publicidad

loading