SICK HSE18L Manual De Instrucciones página 35

1.3 Intended use
8017854.1HW2/2022-11-14 | SICK
Subject to change without notice
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
HSE18L:
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
LASER
1
Figure 11: Laser class 1
This device complies with the following standards:
•
EN/IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
The HSE18 is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals,
and persons. A sender (HS18) and a receiver (HE18) are required for operation. If
the product is used for any other purpose or modified in any way, any warranty claim
against SICK AG shall become void.
The HSE18L is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects. A sender
(HS18) and a receiver (HE18) are required for operation. If the product is used for any
other purpose or modified in any way, any warranty claim against SICK AG shall become
void.
The sensor complies with the Radio Safety Requirements (EMC) for the industrial sector
(Radio Safety Class A). It may cause radio interference if used in a residential area.
OPERATING INSTRUCTION
O P E R A T I N G I N S T R U C T I O N | HSE18(L) 35