Publicidad
Safety precautions
1. The installation must be carried out by quali ed personnel to do electrical installations in accordance with
the regulations in force in the country of installation.
2. Any action performed for the electrical connection of the device, such as its cleaning, must be carried out
after ensuring that the general power supply is disconnected, by removing the corresponding fuse or
disarming the protective switch in order to ensure total isolation of the power supply.
3. The fan must be installed at a location on the ceiling sch that the blades are at least 2.3 m above the oor
and 300 mm from any object or wall. The mounting bracket must be attached to a ceiling structure that is
capable of supporting a minimum of 30 kg using the two screws provided. At least 30 mm of the length of
the screws must be screwed into the bracket. When deciding where to mount the fan, be sure that there is
at least 30 cm of space between the fan and any wall or other obstruction that the fan blades could collide
with. The greater this distance, the more e ective the air ow produced.After the fan is mounted, be sure
that the blades are no less than 2.3 m above the ground.
4. The ground wire of the fan must be connected to the earth network of the installation, to avoid any
derivation that may put people in danger.
5. Do not connect the fan's power supply to any dimmers, potentiometers, or light switches, as it will cause
the fan to malfunction and/or will damage the motor. For the electrical connection it is necessary to incorpo-
rate a switch disconnector in accordance with the installation regulations, which ensures an omnipolar cut,
directly connected to the power terminals and must have a contact separation at all its poles, which
provides total disconnection under conditions of Category III overvoltage. The fan must be directly connec-
ted to a properly protected installation circuit (magnetothermal di erential switch with the adequate size
for the fan's consumption and technical speci cations). Only use the fan's control to turn it on or stop it.
6. It is recommended to not use these types of fans along with gas installations simultaneously in the same
room.
7. The fan must be not be moving and must have come to a complete stop before changing its direction of
rotation. This will prevent damage to its motor and to the control unit, when applicable.
8. Do not insert anything that could hit the fan's blades into its pathway while it is moving, as this could
cause damage to people, can damage the blades, and can o set the balance of the unit, causing vibrations
and wobbling.
9. After installing the fan, ensure that all fastenings are secure and tightened in order to avoid any noise
caused by loose elements.
10. Due to the fan's movement, certain fastenings may become loose. Check all fastenings twice per year at
a minimum in order to ensure that they are su ciently tight. If necessary, they must be retightened.
11. If the power cord is damaged, it must be replaced by the manufacturer, its after-sales service or similar
quali ed personnel in order to avoid any malfunction.
12. The light source of this luminaire must only be replaced by the manufacturer, its technical service or a
quali ed person.
The minimum distance between the lamp and any illuminated objects must be greater than 1m.
The fan must be installed in such a way that the blades are more than 2,3m above the ground.
Make sure that there is a space of at least 30cm between the fan's blades and any wall or other
obstacle that they could hit. It is important to note that the greater the distance, the more
e cient the air ow produced will be.
This device can be used by children aged 8 years and above and people with reduced physical,
sensory or mental abilities or lack of experience or knowledge, if they have been given appropria-
te supervision or training regarding the use of the device and they understand the dangers of its
<8
use. Children should not play with the device. The cleaning and maintenance of the device
should not be carried out by children without supervision.
Publicidad
