VALBERG 10S44 D SAD929C Manual De Instrucciones página 18

B
Using the appliance
Wash cycle table
• The table below shows which programs are best for the levels of food residue on them and
how much detergent is needed. It also show various information about the programs.
• Consumption values and program duration are only indicative except for ECO program.
( ) indicates that the program uses rinse aid in the last rinse.
Detergent
Description of
Program pre/main
cycle
wash
Pre-wash (45 °C)
Wash (55-65 °C)
4/14g
Rinse
Auto (1 tab)
Rinse (50-55 °C)
Drying
Pre-wash (50 °C)
Wash (65 °C)
4/14g
Rinse
Rinse
Intensive
(1 tab)
Rinse (60 °C)
Drying
Pre-wash (45 °C)
Wash (55°C)
4/14g
Rinse
Universal
(1 tab)
Rinse (60°C)
Drying
Wash (50 °C)
18g
Rinse
Rinse (45 °C)
(*EN60436)
(1 tab)
Drying
Pre-wash (40 °C)
Wash (50 °C)
4/14g
Rinse
(1 tab)
Glass Rinse (50 °C)
Drying
Wash (55 °C)
18g
Rinse
Rinse (50 °C)
90 min (1 tab)
Drying
Wash (40°C)
12g
Rinse (40°C)
Rapid
Rinse (55°C)
32
Running Energy Rinse
Water (L)
time(min) (kWh) aid
85-150 0.615~1.201 9.2~13.9
205 1.129 14.1
175 0.930 13.9
198 0.674 8.5
120 0.671 11.3
90 0.620 8.4
30 0.742 10
EN
B
Using the appliance
Detergent
Description of
Program pre/main
cycle
wash
Prewash
Soak
NOTE
The ECO program is suitable to clean normally soiled
tableware, that for this use, it is the most efficient program
in terms of its combined energy and water consumption,
and it is used to assess compliance with the EU ecodesign
legislation.
Saving energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water
in the use phase than hand dishwashing when the household dishwasher is used according
to the instructions.
Starting a programme
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche". Make
sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause button, the
dishwasher will start its cycle.
Changing the program mid-cycle
• A programme can only be changed if it has been running only for a short period of time,
otherwise the detergent may have already been released or the the wash water with
detergent has already been drained. If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be refilled.
33
Running Energy Rinse
Water (L)
time(min) (kWh)
15 0.018 3.6
EN
aid