Mennekes AMTRON Compact 2.0s 11 Manual De Instrucciones Y De Instalación página 52

Inside view
8
7
6
Fig. 4: Inside view
1 Cable glands *
2 Solar button
3 Terminals
n 3 and 4: Downgrade input
n 5 and 6: External shunt release switching
output
4 Terminals to connect the data line (for Mod-
bus RTU)
5 MCU (MENNEKES Control Unit)
6 DIP switch
7 Connection for the MENNEKES configuration
lead
8 Terminals for voltage supply
* Additional cable glands are located on the top
and bottom.
3.5 Solar charging modes
The product has 3 charging modes (Standard
mode, Sunshine mode, Sunshine+ mode).
8
1
2
3
4
5
Standard mode
Charging occurs at maximum power. Mains power
is used for charging unless there is a sufficient
amount of excess energy.
Sunshine mode
The charging power is dependent on the excess
energy from the photovoltaic system. Solar energy
exclusively is used for charging. The charging pro-
cess starts if there is a sufficient amount of energy
available to charge the vehicle at 6 A per phase.
Sunshine+ mode
The charging power is dependent on the excess
energy from the photovoltaic system. Regardless of
how much current the photovoltaic system is feed-
ing at the time, the vehicle is provided with min-
imum charging current at all times (if necessary
through mains power). The minimum charging cur-
rent (standard: 6 A per phase) can be adjusted us-
ing the configuration tool (a qualified electrician is
required).
Detailed information regarding the Sun-
shine mode and Sunshine+ mode can be
found in chapter:
1 "6.2.3 Solar charging" [
3.6 LED information panel
The LED information panel shows the operating
status of the product (e.g. standby, fault).
Standby
Symbol Meaning
lights up The product is ready for use. No
vehicle is connected to the product.
25]
}