Publicidad
Idiomas disponibles
Idiomas disponibles
n The Sun button has no function unless
solar charging has been set up.
The following information applies to both
the 22 kW and 11 kW variants with enabled
dynamic phase switchover:
n Switching between Standard mode, Sun-
shine mode and Sunshine+ mode is al-
ways possible (also while charging is in
progress).
The following information applies to the
11 kW variant with disabled dynamic phase
switchover:
n Switching between Sunshine mode and
Sunshine+ mode is always possible (also
while charging is in progress).
n Switching between Standard mode and
Sunshine(+) mode is not possible while
charging is in progress. The vehicle must
be disconnected from the charging sta-
tion before switchover.
Charging process does not start
If the charging process does not start, the commu-
nication between the charging point and the
vehicle may be faulty, for example.
u Check the charging plug and the charging
socket for foreign objects and remove if neces-
sary.
u Have the charging cable replaced by a qualified
electrician if necessary.
Ending the charging process
ATTENTION
Material damage due to tensile stress
Tensile stress on the cable may cause cable breaks
and other damage.
u Pull the charging plug out of the charging
socket.
u End the charging process on the vehicle or by
holding the RFID card in front of the RFID card
reader.
u Pull the charging plug out of the charging
socket.
u Put the protective cap on the charging plug.
u Hang the charging cable kink-free.
EN
35
Publicidad
