Kärcher HD 7/11-4 Cage Manual Del Usuario página 22

– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
High pressure operation
Appliance  Set the appliance switch
with hold-
er for trig-  Remove the hand spray
ger gun (A)
Appliance  Set the appliance switch
with pres-
sure
switch (B)
Appliance  Set the appliance switch
without (A)
and (B)
 Unlock the trigger safety and pull the le-
ver of the trigger gun.
 Set working pressure and flow rate
through turning (runless) at the pres-
sure- and amount regulation (B) (+/-).
Interrupting operation
Short break
 Release the lever on the trigger gun.
Appliance with pressure switch (B)
switches off.
Appliances without pressure switch go
into circuit operation.
 Release the lever of the trigger gun
again.
Appliance with pressure switch starts.
Appliances without pressure switch end
circuit operation.
22
to "I".
gun from the holder,the
appliance switches on.
to "I".
The appliance is ready for
operation and starts when
the lever of the trigger gun
is pulled.
to "I".
The appliance switches on.
Longer break
 Release the lever on the trigger gun.
 Operate the trigger safety of the trigger
gun to secure the lever of the gun
against accidental triggering.
Appliance  Place the trigger gun into
with hold-
er for trig-
ger gun (A)  Remove trigger gun from
Appliance  Set the appliance switch
with pres-
sure
switch (B)  Set the appliance switch
Appliance  Set the appliance switch
without (A)
and (B)
 Set the appliance switch
 Unlock the trigger safety and pull the le-
ver of the trigger gun.
Turn off the appliance
 Set the appliance switch to "0".
 Disconnect the mains plug from the socket.
 Shut off water supply.
 Activate trigger gun until device is pres-
sure-less.
 Operate the trigger safety of the trigger
gun to secure the lever of the gun
against accidental triggering.
– 7
EN
the holder.
The pump stops.
the holder.
The pump starts.
to "0/OFF".
The pump is switched off.
to "I".
The pump is ready for op-
eration.
to "0/OFF".
The pump is switched off.
to "I".
The pump starts.