HT SOLAR-02 Manual De Instrucciones página 20

SOLAR-02
20
2
PRECAUTIONS AND
SAFETY MEASURES
The instrument was designed in compliance with the requirements of
R&TTE Directive as well as of harmonized directives for electronic measuring
instruments. Before and during measurements, carefully observe the following
instructions:
• Do not perform any measurement in humid environments, in the presence of
gas or explosive or inflammable material or in dusty areas.
• Avoid any contact with the circuit to be tested if no measurements are being
carried out.
• Avoid any contact with exposed metal parts, with unused measuring leads,
circuits, etc.
• Do not perform any measurement when anomalies are found in the instrument,
such as deformations, breaks, substance leaks, no display view, etc.
• Only use HT original accessories.
• Only use HT original accessories.
CAUTION
In accordance with the recommendations of the European Council 1995/519/
EC and the standard EN62311, the instrument can be used safely while you are
holding it in your hands. Under this circumstance power levels with 2.4GHz
transmission are thoroughly covered as per the basic restrictions for human
exposure to RF according to the above mentioned European rules
CAUTION
Warning: observe the instructions reported in the manual. An improper use
could damage the instrument or its components
2.1
PRELIMINARY INSTRUCTIONS
• This instrument has been designed for use in the environmental conditions
specified in § 7.3
• We recommend following the usual safety rules to protect yourself from
dangerous voltages and currents and to protect the instrument against
improper use
• Do not apply any voltage to the instrument's inputs
• Only the accessories supplied with the instrument guarantee safety
standards. They must be in good conditions and replaced, if necessary, with
identical models
• Do not subject the input connectors of the instrument to strong mechanical
stress
• Check that the batteries are correctly inserted
CAUTION
The RF connection of remote unit SOLAR-02 is normally disabled for default.
For use of this unit with the Master meter "M-RF" (see Table 1) is necessary
to activate the RF connection (see § 5.6.1)
Rel. 4.00 - 22/11/22