HT SOLAR-02 Manual De Instrucciones página 27

SOLAR-02
5.6.2
USE OF THE UNIT
1. Switch on and approach the unit SOLAR-02 to the master instrument (max
distance 1m). The symbol " ":
• Is blinking approx 30s at display while searching a M-RF master unit
• Is fixed at display when a M-RF master unit is found
• Disappears from display if no M-RF master unit is found within approx 30s.
Press the ▼ key for re-start a new search of a "M-RF" master unit
2. Press the SET key. The unit shows the screen beside in which sensor 1 is
selected.
3. Use the arrow keys ▲and ▼ to select the desired type of sensor considering
the unit programming (see § 5.2)
4. Confirm selection with the SET key to go back to the measuring mode
5. With operative RF connection, by activating a testing/recording on the
master instrument, the unit SOLAR-02 waits for the synchronization,
showing the message "HoLd" on the display and the indication of the time
during which it is necessary to keep the unit SOLAR-02 near the master
instrument before being able to activate the testing procedures
6. Once the waiting phase (HOLD) has ended, the message "Recording..." will
be displayed. It is now possible to take the unit SOLAR-02 away from the
master instrument and take it near the PV modules. Possible hyphens "- - -"
indicate that no irradiation and temperature probes are connected to the
unit SOLAR-02 yet
7. Place the Irradiance probe (Irr-P or Irr-S2 – see Table 1) parallel to PV
modules surface and connect the output connector to SOLAR-02 PYRA/
CELL input
8. Using a tape fix the temperature probe (Tmp – see Table 1) on the backside
of the module and connect the output connector to SOLAR-02 TEMP input
9. Upon reaching an irradiation value higher that the threshold set by the
MASTER instrument, the unit SOLAR-02 shows the message "READY" on
the display
10. Disconnect the
take the unit again near the master instrument in order to activate the RF
connection
11. Approach the unit SOLAR-02 to the master instrument (max distance 1m):
• If the " " symbol is blinking at display wait for the reciprocal detection of
both units and after this the symbol is fix at display
• If the " " is missed at display press the ▼key for restart a new search of a
"M-RF" master unit
12. Upon detecting the control to stop testing/recording from the master
instrument, the unit stops working, shows on the display the message
"SEnd" and sends the data to the master instrument
Rel. 4.00 - 22/11/22
irradiation and temperature
EN
probes and
27