Metabo HPT C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones página 25

4. Cutting narrow workpieces (Press cutting)
Hinge
Holder (A)
Fig. 26
5. Cutting large workpieces
6 mm fl ad hd. screw
6 mm nut
Fence
Fig. 27
6. Cutting wide workpieces (Slide cutting)
1 Pull forward
3 Push rearward
to cut
Fig. 28
Handle
Press
down
Workpiece
There may be case when a complete cutting cannot be done
depending on the height of workpiece. In this case, mount
an auxiliary board with the 6 mm fl at head screws and the
6 mm nuts using the 7 mm holes on the fence surface (two
holes on each side). (Fig. 27)
Refer to page 10 "SPECIFICATIONS" for the thickness of the
Auxiliary
auxiliry board.
board
Handle
2 Press
down
Workpiece
Slide the hinge down to holder (A), then tighten
the slide securing knob (see Fig. 2) as indicated
in Fig. 26
Lower the handle to cut the workpiece.
Using the power tool this way will permit cutting
of workpieces of up to 4-3/16" (107 mm) square.
(1) Workpieces up to 4-3/16" (107 mm) high
and 12-1/4" (312 mm) wide:
Loosen the slide securing knob (A) (see
Fig. 2), grip the handle and slide the saw
blade forward.
Then press down on the handle and slide
the saw blade back to cut the workpiece as
indicated in Fig. 28. This facilitates cutting
of workpieces of up to 4-3/16" (107 mm) in
height and 12-1/4" (312 mm) in width.
(2) Workpieces up to 4-11/16" (120 mm) high
and 10-3/16" (260 mm) wide:
Workpieces of up to 4-11/16" (120 mm)
in height and up to 10-3/16" (260 mm) in
width can be cut in the same manner as
described in paragraph 6-(1) above.
English
25