Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
8.
Bevel angle fi ne adjustment
Handle
(1)
Grip the handle on the motor head and position it at the bevel angle you need.
(2) After adjusting to the desired angle, tighten the clamp lever and clamp the motor head.
CAUTION:
If the handle is raised while the saw blade is still rotating, the
cut-off piece may become jammed against the saw blade causing
fragments to scatter about dangerously.
When stopping the bevel cutting operation halfway, start cutting
after pulling back the motor head to the initial position.
Starting from halfway, without pulling back, causes the lower
guard to be caught in the cutting groove of the workpiece and to
contact the saw blade.
When cutting a workpiece of 2-15/16" (75 mm) height in the left 45°
bevel cutting position or a workpiece of 1-15/16" (50 mm) height in
the right 45° bevel cutting position, adjust the lower limit position
of the motor head so that the gap between the lower edge of the
motor head and the workpiece will be 5/64" to 1/8" (2 to 3 mm) at
the lower limit position (refer to "3. Lower limit position of saw
blade when cutting a large workpiece" on page 17).
Clamp lever
8 mm bolt (B)
Fig. 30
* If not tightened fi rmly enough the motor head might suddenly
move or slip, causing injuries. Be sure to tighten the motor head
section enough so it will not move.
* Always check that the clamp lever is secured and the motor
head is clamped. If you attempt angle cutting without clamping
the motor head, then the motor head might shift unexpectedly
causing injuries.
English
Clamp lever
Fig. 31
27
Publicidad
Tabla de contenido
