Preparation Before Operation - Metabo HPT C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones

English
APPLICATIONS
Wood and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Remove all packing materials attached or connected to the tool before attempting to operate
it.
2. Installation
11/32" (9 mm)
4 holes
12-7/8"
(327 mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40 mm) plus the thickness of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a 1" (25 mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Holder
Move
Adjust the holder until its bottom surface contacts the
work bench surface.
12
11-1/18"
(282 mm)
Fig. 5
Base 5/16" (8mm) bolt
Work bench
Fig. 4
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm box
wrench.
Adjust the holder until its bottom surface
contacts the work bench surface.
After adjustment, fi rmly tighten the 6 mm
6 mm
Bolt
bolt.
5/16" (8 mm) nut