Publicidad
Idiomas disponibles
Idiomas disponibles
11
Parameter's index
FACTORY
PARAM.
VALUE
64
Automatic closure after pause time (from gate completely open)
Automatic gate closing after mains power outage
Selecting step mode control function (PP)
Condominium function for partial open command (PED)
Enabling operator present function.
Gate open indicator / photocell test function and "battery saving"
Setting deceleration during opening
Setting deceleration during closing
Setting gate opening stop constant speed approach distance
Setting gate closing stop constant speed approach distance
Partial opening adjustment (%)
COR output operating mode
Setting automatic closing time
Enabling of management for opening with automatic re-closure exclusion
Tolerance on the opening stop
Tolerance on the closing stop
Advance on stop in full opening
Advance on stop in full closing
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
Setting motor torque
Setting obstacle impact force sensitivity
Setting start acceleration during opening
Setting start acceleration during closing
Enabling maximum torque boost at start of manoeuvre
Setting motor torque during position recovery
Setting opening speed
Setting closing speed
Setting end of manoeuvre constant approach speed
Setting number of automatic closure attempts after activation of sensing
edge or obstacle detection (crush protection)
Setting photocell mode during gate opening (FT1)
Setting photocell mode during gate closing (FT1)
Photocell (FT1) mode with gate closed
Setting photocell mode during gate opening (FT2)
Setting photocell mode during gate closing (FT2)
Photocell (FT2) mode with gate closed
Enable close command 6 s after activation of photocell (FT1-FT2)
Setting motor stop distance
Selecting installation position of motor relative to gate (seen from interior
side)
DESCRIPTION
PAGE
66
66
66
66
66
66
66
67
67
67
67
67
67
67
67
67
68
68
68
68
68
68
68
68
68
68
69
69
69
69
69
69
69
69
69
70
70
70
70
Publicidad
