Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 2: Align the workpiece
note:
if the material is bent off-centre, a risk exists that the bending die will break, jam or damage
the main body of the device.
• Make sure that you insert the material correctly in the centre for the bending process.
• Insert the workpiece between the bending die and the bending mandrel.
The material must lie flat on both table tops. The busbar is to be positioned so that that the centre
of the bend coincides with the laser point or that the side edge is aligned with the set stop.
• Close the protective hood.
note:
the protective hood is connected to an internal safety switch.
the work process cannot be initiated when the protective cover is open.
it is possible at any time to end the application by lifting the protective cover.
warning!
A risk exists of smaller particles being ejected from the processing area at high speed
!
when the busbars are bent.
• wear personal protective equipment when working on the device
(see section "personal protective equipment").
22
Publicidad
