Publicidad
Idiomas disponibles
Idiomas disponibles
This pictogram indicates an electrocution hazard. Please isolate the machine before
carrying out any work on it. You will find this pictogram at the back of the machine
close to the power cable and inside the machine on the electrical enclosure (fig.8,
n°25).
You will find the circuit diagram for the machine on the back of the electrical
enclosure door (fig.8, n°26).
5.4
Commissioning
Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
For machine operation, please refer to the "Operation" chapter.
5.5
Hazard
If the user or the machine is in danger, use the main isolator switch to cut the power supply to the machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Wear gloves for any maintenance or cleaning work by the blade.
To replace the blade, have the work done by your approved dealer.
Always wear cut-resistant gloves when replacing the blade or when working in the vicinity of the blade.
Any work involving maintenance or replacement of parts must be carried out by a qualified individual.
This pictogram indicates a cut hazard. You will find this pictogram at the back of the
machine close to the power cable (fig.8, n°27) and inside the machine on the blade
guard (fig.1, n°6).
6
CONTROL AND SAFETY DEVICES
6.1
Controls
Your slicer is fitted with a touch screen, a screen with a capacitive interface or a 3-button panel (fig.9).
If your slicer has the pro VMP – VMA configuration, the touch screen consists of the following elements:
1. Slice thickness
2. Number of slices
3. Cutting speed
4. Choice of 4 cutting modes:
a. Cut whole loaf,
b. Cut a number of slices,
c. Cut half the loaf into slices,
d. Cut loaf in half,
5. Start cutting
6. Advanced settings. This button accesses the slicer cleaning mode (n°38) and the Easymode
settings (n°42).
English
10
Publicidad
