Section 6; Maintenance And Repair; Section 7; Technical Documents Of Products - Ega Master 55815 Manual De Instrucciones

Maintenance and repair must be operated by proficient technician.
To guarantee the machine to work well, original parts and accessories are preferable.
Caution: before equipment maintenance, make sure the power is cut off.
Keep original package well to transport equipments and accessories conveniently and promptly.
Keep the equipment clean to make the equipment work on the optimal condition.
After using every time, the equipment should be cleaned by brush and grease antirust.
Don't put the equipment in the humid and dirty place.
Caution: don't put any thing on the rotation axis.
Caution: clean the equipment with brush.
Warn: Don't clean equipment with compressed air.
Before using every time, please clean the equipment and ensure no remains.
Take apart the work piece and grease lubricant by professionals every year.
Clean the machine regularly and check the using condition of spoilage work pieces. If put the machine in
the storage case, operate as follows:
1. Check the power cord.
2. Check the tension of Tool Slide. If loose, adjust the wedge snail on the Tool Slide.
Adjust the tension of Tool Slide:
1. Tighten the inner Hex Screw, Tool Slide touches a little.
2. Rotate the Star wheel to check the tension of recheck the Tool Slide.
BEARING SYSTEM:
Caution: Do not move the bearing off the set-point, or the ring probably cause damage. The Bearing
system of equipment have been set when the machine leaves the factory. The adjustment of all the bearing
system must be operated by maintenance technician granted by Our Company. If need support or help,
please contact Our company or local representative.
Technical documents of products include general assembly chart of machines. Please refer to instruction
appendix for details, as follows:
a) Main Machine Chart
b) Tool Slide Chart
Trouble
Machine won't work
Work piece shifts during
cutting operations
Poor machining quality
Tool Slide can not feed
Tool bit jumps and jams
20

SECTION 6

MAINTENANCE AND REPAIR

SECTION 7

TECHNICAL DOCUMENTS OF PRODUCTS

SECTION 8

TROUBLES AND SOLUTIONS

Possible Cause
Power cord or air supply not
connected
Loose fixed clamp
Blunt and damaged tool bits
Broken cutter head or not on the
working position
Planet gear on the tool slide not
well adjusted
Solution
Check power cord or air supply
Check tension on fixed clamp
handle
Replace or scrape the tool bit
Replace cutter head or adjusted to
the working position
readjust