WAGNER 3566 Manual Del Propietário página 10

CLEAN UP
Overnight Storage
Shutdown
1. Lock the gun by turning the gun safety switch parallel with
the gun body.
2. Turn the pressure control knob counterclockwise to the
minimum setting.
3. Turn the PRIME/SPRAY knob to PRIME (
4. Turn the motor switch to OFF and unplug the sprayer.
5. For latex materials only, pour 1/2 cup water slowly on the
top of the paint to prevent the paint from drying. For other
materials, seal the paint container with a piece of plastic
while the suction tube is still in the paint.
6. Wrap the spray gun assembly in a damp cloth and place it
in a plastic bag. Seal the bag shut.
7. Place the sprayer in a safe place out of the sun for short-
term storage.
Startup
1. Remove the gun from the plastic bag.
2. Stir the water into the paint for latex materials. Remove
the seal from the paint bucket and stir the paint for all
other materials.
3. Check to be sure that the PRIME/SPRAY knob is set to
PRIME ( ) and that the pressure is completely reduced.
4. Plug sprayer in and turn the motor switch to ON.
5. Turn the PRIME/SPRAY knob to SPRAY (
gradually turn the pressure control knob clockwise to
increase the pressure.
6. Test the sprayer on a practice piece and begin spraying.
R English
).
- or -
) and
Long-term Storage
WARNING
Do not allow paint to build up on the motor or the motor
will overheat. Do not allow flammable solvents to come in
contact with the motor or they could ignite.
NOTE: You will need a bucket, cleaning solution, a
toothbrush, an adjustable wrench and cleaning rags.
Clearing the Suction Tube
1. Lock the gun by turning the gun safety switch parallel with the gun
body.
2. Turn the pressure control knob counterclockwise to the
minimum setting.
3. Turn the PRIME/SPRAY knob to PRIME (
4. Turn the motor switch to OFF and unplug the sprayer.
5. Remove the suction tube from the paint and hold it above a
bucket of water or solvent. Leave the return tube in the paint
bucket.
NOTE: If spraying with latex paint, use warm soapy
water for cleaning. If using oil or alkyd-based
paints, use mineral spirits or paint thinner.
CAUTION
Do not use mineral spirits or paint thinner on latex paint,
or the mixture will turn into a jellylike substance which is
difficult to remove.
6. Plug the sprayer in and turn the motor switch to ON.
7. Turn the pressure control knob to 1/2 maximum pressure.
This will draw the remaining paint in the suction tube through
the pump, down the return tube and into the paint bucket.
8. Turn the pressure control knob counterclockwise to the
minimum pressure setting.
9. Trigger the gun to relieve pressure and lock the gun.
10. Remove the spray tip, guard and washer and place them
into a container of water or appropriate solvent for the
type of material with which you are painting.
11. Place the attached suction tube and return tube into a
container of water or appropriate solvent for the type of
material with which you are painting.
12. Increase the pressure to 1/2 the maximum pressure. Let
the water or solvent circulate for 2-3 minutes to flush paint
out of the pump, the suction tube and the return tube.
Clearing the Paint Hose
1. To save paint left in the hose, release the gun safety
switch and carefully trigger the gun with the spray tip
removed against the inside of the paint container.
2. Turn the pressure control knob counterclockwise to the
minimum pressure setting.
3. Turn the PRIME/SPRAY knob to SPRAY (
4. Turn the pressure control knob slowly until paint starts to
10 © 1996 Wagner Spray Tech - All rights reserved.
)
).