SCHUBERTH S3 Manual página 73

C. THE HELMET
3. The back pad is linked to the helmet with
the plug-in devices held by the cheek pads.
to install it is necessary to install the cheek
pads as well.
Installation the cheek pad
1. Slide the chin strap through the cheek
pad pocket.
2. Connect the pins of the cheek pads with
the corresponding plug-in devices.
3. Insert the front bayonet of the cheek pad
over the pin, located inside the lower trim,
and successively push the rear of the cheek
pad to snap the eyelet over the pin.
4. Repeat points 1 to 3 for the installation of
the cheek pad on the other side.
EN
73