Publicidad
Idiomas disponibles
Idiomas disponibles
D. FILLING BOILER WITH WATER
WARNINGS:
• Carefully read all instructions before removing Boiler Cap.
• Always unplug appliance before filling the Boiler
IMPORTANT
*
*
water is recommended if tap water is too hard. DO NOT add detergents,
perfumes, oils, or other chemical substances to the Boiler. The product
warranty will be null and void if anything other than water is added to the
Boiler.
Follow these instructions to fill the Boiler:
• Make sure appliance is unplugged from the
electrical outlet and has cooled for at least 5
minutes before filling with water.
• Make sure Handle Assembly is in the upright
"OFF" position. Remove Boiler Cap by turning it
counterclockwise.
• Keeping the handle assembly pushed forward (A),
place the filling bottle upside down and insert the
nozzle inside the boiler opening (B). Press firmly
on the bottle to deactivate the locking mechanism
to release water. The filling bottle allows you to fill
the boiler to correct level, avoiding overfilling.
• Keep the handle assembly pushed forward (A)
while removing the bottle.
• Replace Boiler Cap by turning it clockwise. Do not
tighten Boiler Cap too much, finger tightening is
sufficient to lock the steam in the Boiler. If using
cold water, heating time is about 3-5 minutes. If
using warm water, heating time is reduced.
IMPORTANT
*
*
• Use the filling bottle when refilling your Boiler. The filling bottle has a
built-in mechanism that prevents overfilling your Boiler. If you use a
measuring cup to refill, add a maximum of 600ml (2 1/2 cups) of water
when the Boiler is empty.
• If re-filling the Boiler while Steam Cleaner has been in use, be sure to
allow it to cool for at least 5 minutes and loosen Boiler Cap slowly to
allow any excess steam to escape before completely removing Cap (See
page 13, "Refilling Boiler During Use" for detailed instructions).
Use ordinary tap water. Demineralized or distilled
Before Use
11
Publicidad
