Publicidad
Idiomas disponibles
Idiomas disponibles
• Unplug the appliance from the electrical outlet.
• Place Handle in the "ON" position to release any residual steam and
pressure from the Boiler.
• Slowly turn Boiler Cap counterclockwise. This will allow remaining
steam to slowly escape.
• Make sure Steam Cleaner has cooled 5 minutes before refilling
with water.
The product warranty will be invalidate if anything
other than water is added to the Boiler.
• Be sure Handle Assembly is in the upright
"OFF" position. Remove Boiler Cap by turning
it counterclockwise.
• Keeping the handle assembly pushed forward
(A), place the filling bottle upside down and
insert the nozzle inside the boiler opening (B).
Press firmly on the bottle to deactivate the
locking mechanism to release water. The filling
bottle allows you to fill the boiler to correct level,
avoiding overfilling.
• Keep the handle assembly pushed forward (A) while removing the
bottle.
• Replace Boiler Cap by turning it clockwise. Do not tighten Boiler
Cap too much, finger tightening is sufficient to lock the steam in the
Boiler. If you use cold water, the heating time is about 3-5 minutes. If
you use hot water, the heating time is reduced.
• Insert the plug into electrical outlet. Wait for green Steam Ready
Indicator Light to turn on. Steam Cleaner is ready to use once again.
REMINDERS
• Always use ordinary tap water.
• If tap water is too hard, use distilled or demineralized water to avoid
the risk of mineral deposits and sediment from forming.
• Do not add detergents, perfumes, oils or other chemical substances
to the Boiler. This will damage the Steam Cleaner and void the
warranty.
• The green Steam Ready Indicator Light will turn on and off during
use. This is normal and not a fault.
IMPORTANT
*
Do not overfill the Boiler as excess water will be flushed out of the
Boiler before dry steam will emit.
14
Using the Steam Cleaner
*
Publicidad
