RIDGID 1215 Manual Del Usuario página 7

Die Head
Chuck
Handwheel
Rear
Centering
Device
On/Off
Switch
Foot
Switch
Warning
Label
Figure 1A – 1215 Threading Machine (Front)
Drip Tray
Serial Number
Plate
Figure 1B – 1215 Threading Machine (Back)
Specifications
Threading Capacity ........Pipe 1/4" to 1 1/2"
(6 to 37 mm)
Bolt 5/16" to 1" (8 to 25 mm)
Right Hand Threads Only
Motor:
Type .................................Universal, Single Phase
Power ..............................1/2 HP (0.37 kW)
Volts .................................120 V, 50/60 Hz
No Load Speed Ƞ o ..........44 RPM
Controls ...........................Rocker Type ON/OFF (I/O)
Switch and ON/OFF Foot
switch
Front Chuck ..................... Hammer-Type with Replaceable
Rocker-Action Jaw Inserts
Rear Centering Device ... Cam Action
999-997-051.10_REV B
No. 732
Cutter
No. 323
Reamer
Carrying
Handle
Chip Tray
Carriage
Handwheel
Cord Wrap
Carrying
Handle
1215 Threading Machines
Die Heads ...................... See RIDGID Catalog for Avail-
able Die Heads
Cutter ............................. Model 732, Roll Type Cut-Off,
Self-Centering Cutter
Reamer ........................... Model 344, Five Fluted Type
Oil System ....................... 1.5 qt (1,4 l) Reservoir Capacity,
Self-Priming, Gerotor Pump,
Adjustable Flow Rate
Dimensions ..................... 23" x 17 .5" x 18" (584mm x
444mm x 457mm) (With Tools
In Operating Position and Cutter
Fully Closed)
Weight ............................. 80 lbs. (36 kg)
Sound Power
(L )* ...............................82.1 dB(A)
WA
* Sound measurements are obtained in accordance with CSA Z107 .2-1973 and
OSHA 1926.52
- Sound emissions may vary due to your location and specific use of these tools.
- Daily exposure levels for sound need to be evaluated for each application and
appropriate safety measures taken when needed. Evaluation of exposure levels
should consider the time a tool is switched off and not in use. This may signifi-
cantly reduce the exposure level over the total working period.
Standard Equipment
Refer to the RIDGID catalog for details on accessories
supplied with specific machine catalog numbers.
The RIDGID Model 1215 Threading Machine serial num-
ber plate is located opposite the switch plate below the
foot switch cord wrap. The last 4 digits indicate the month
and year of the manufacture. (mm = month, yy = year).
XXXXXXXXMMYY
Figure 2 – Machine Serial Number
NOTICE
Selection of appropriate materials and instal-
lation, joining and forming methods is the responsibility
of the system designer and/or installer. Selection of im-
proper materials and methods could cause system failure.
Stainless steel and other corrosion resistant materials can
be contaminated during installation, joining and forming.
This contamination could cause corrosion and premature
failure. Careful evaluation of materials and methods for
the specific service conditions, including chemical and
temperature, should be completed before any installation
is attempted.
5
5