Preparing To Work - GGP ITALY BKE 27 Manual De Instrucciones

MACHINE ASSEMBLY / PREPARING TO WORK
– Remove the cutting line head (1) unscrewing it in
a clockwise direction.
• Fitting
– Ensure that the grooves in the inner ring-nut (4)
match up perfectly with the angle tranmission (3).
– Fit the cutting line head (1) screwing it up in an
anticlockwise direction.
– Remove the wrench (2) to restore shaft rotation.

5. PREPARING TO WORK

CHECKING THE MACHINE
Before starting work please:
– check that all the screws on the machine and the
cutting device are tightly fastened;
– check that the cutting device is undamaged and
that the 3-point metal blades (if fitted) are prop-
erly sharpened;
– check that the air filter is clean;
– check that the protection devices are well fas-
tened and working efficiently;
– check the handgrips are well fastened.
PREPARING THE FUEL
This machine is fitted with a two-stroke engine
which requires a mixture of petrol and lubricating
oil.
IMPORTANT
mage the motor and will cause for invalidation of
the warranty.
IMPORTANT
oils to maintain high performance and guarantee
the duration of the mechanical parts over time.
Using petrol alone will da-
Only use quality fuels and
• Adjusting the guard
– Fit the additional guard (5), inserting the couplers
into the respective seatings in the guard (6) and
pressing until a click is heard.
line head the additional guard, with line cutting
knife, must always be fitted.
• Petrol characteristics
Only use unleaded petrol with a fuel grade of at
least 90 N.O.
IMPORTANT
ate deposits in the container if preserved for more
than 2 months. Always use fresh petrol!
• Oil characteristics
Only use top quality synthetic oil specifically for
two-stroke engines.
Your dealer can provide you with oils which have
been specifically developed for this type of engine,
and which are capable of guaranteeing a high level
of protection.
The use of these oils makes it possible to prepare
a 2% mixture, consisting in 1 part oil to 50 parts
petrol.
• Preparation and preservation of the fuel
mixture
are highly inflammable!
EN
When using the cutting
Unleaded petrol tends to cre-
Petrol and the fuel mixture
7